Occupation Health Testing Bristol, FL
If you are an employer or individual in need of occupational health testing services, Occupational Health Testing USA provides occupational health screenings for all OSHA and DOT job requirements at many locations in Bristol, FL and the surrounding areas. Our occupational health testing services are available for employers in need of pre-employment, post-accident, fit for duty or annual testing requirements. We also provide testing for individuals in need of any employment or personal related health evaluations. In many cases, our Bristol, FL locations are within minutes of your home or office and same day service is available.
Occupational Health Services In Bristol, FL
- DOT Physicals (FMCSA, PHMSA, FAA, FRA, FTA, USCG 719K/E)
- Pre-Employment Physicals
- Audiograms
- TB Chest X-ray
- EKG
- Lab Metabolic Panel
- Lab Lipid + Glucose Panel
- Lab – Hep B Panel
- Lab- MMR Titer
- Kraus Weber Lower Back Evaluation
- Lift Test
- OSHA Respirator Questionnaire
- Respirator Fit Test – Qualitative
- Respirator Fit Test – Quantitative
- Hep B Vaccination
- MMR Vaccine
- TDAP Vaccine
- TP/PPD Skin Test
- Varicella Vaccine #1
- Vision Test Ishihara
- Vision Test Snellen
- Vision Test Jaeger
- Drug Testing
- Alcohol Testing
Occupational Testing Locations in Bristol, FL
(Not All Testing Centers Perform All Tests)
20370 NE BURNS AVE 4.7 miles
BLOUNTSTOWN, FL 32424
What is Occupational Health
Occupational health is a field of healthcare involving multiple fields dedicated to the well-being and safety of employees in the workplace, with a strong focus on injury prevention and education. Some occupational health services include employee wellness, Pre-placement services, ergonomics, occupational therapy, and occupational medicine.
Occupational health refers to the identification and control of the risks arising from physical, chemical, and other workplace hazards in order to establish and maintain a safe and healthy working environment. These hazards may include chemical agents and solvents, heavy metals such as lead and mercury, physical agents such as loud noise or vibration, and physical hazards such as electricity or dangerous machinery.
Since 1986, the NIEHS has supported training and education programs designed to protect workers and their communities from exposure to toxic materials encountered during hazardous waste operations and chemical emergency response. This includes safety and health training for workers who are involved in hazardous waste removal and comprehensive training and environmental restoration for residents living near heavily polluted industrial waste sites.
Local Area Info: Bristol Lodekka
The Bristol Lodekka was a half-cab low-height step-free double-decker bus built by Bristol Commercial Vehicles in England. It was the first production bus design to have no step up from the passenger entrance throughout the lower deck, although Gilford and Leyland Motors had developed low floor city buses in the 1930s, these did not enter production.
The point of its design and introduction was to end the uncomfortable and inconvenient Lowbridge double-deck bus layout, replacing it by lowering the chassis frame and integrating it with the body, and fitting a drop-centre rear axle, so that there were no steps from the rear entrance platform to the front of the passenger gangway, itself sunk about 10 cm (6 inches) below the seating platforms on the LDX, LD and first five LDLs. A full flat floor was developed on the last LDL, then used on the LDS and the F series Lodekkas. Bristol Commercial Vehicles, Eastern Coach Works and some of their employees obtained a number of patents relating to the design.
Bristol manufactured over 5,200 Lodekkas from 1949 to 1968, as a standard double-deck vehicle for the UK state-owned bus sector. With all examples bodied by Eastern Coach Works in Lowestoft, they have a traditional half-cab design and a lower floor level allowing a low overall height. The earlier LD-series and the later FL and FS had a rear platform, but the FSF and FLF had a forward (behind the front axle and driver's position, rather than 'front' ahead of the front axle and alongside the driver) entrance. Most were powered by 5 or 6-cylinder Gardner engines, with fewer having a Bristol or Leyland power unit.
For more information or to schedule an occupational health testing service call our scheduling department or schedule your test online 24/7.